UL350iSA

  • 81kg
  • 130hp
  • contact us

The UL350ISA is the engine that will turn your head upside down.
A modified engine casing, oil sump and oil pick up system, designed by our very own ULPower team, and an additional inverted oil system allows the ULPower engines to fly inverted.

This inverted oil system copes with potential lubrication issues.
The oil pick-up tube in the oil sump is mounted with a hinge joint. While climbing or diving up to an angle of 90°, the oil pump can pick up the oil from the sump without any problem.
The oil inverted valve can change the pick-up direction while climbing or inverted flying, this means that the oil is coming from the top of the engine casing (which is now the lowest point).
The large (but light) “oil air breather” prevents the oil from leaving the engine.

The fuel injection system (instead of carburetor) prevents the engine from stopping or losing fuel when flying inverted.
IMPORTANT REMARK: modification in your fuel tank is needed to prevent engine from sucking air.

Oil capacity : Oil sump must be filled with 4 liter oil (1.06US gal).

  • 4 stroke, 4 cylinder, horizontally opposed
  • Dual (redundant) electronic spark ignition (variable timing)
  • Electronic multipoint fuel injection (pressure and temperature compensated)
  • Electronic RPM limiter
  • Direct propeller drive
  • 5 bearing crankshaft with surface hardening treatment and additional large thrust bearing (ball bearing type)
  • Single central camshaft
  • Push rods, tappets and OHV (hydraulic compensators have not been used)
  • Wet sump forced lubrication with integrated pressure regulator
  • Ram air cooled cylinders and cylinder heads
  • Integrated permanent magnet AC generator, external rectifier-regulator
  • Electric starter
  • Electric fuel pump and pressure regulator to eliminate vapor lock and facilitate starting even under adverse conditions



Displacement 3503 cc [213.77 cu in]
Bore 105.6 mm [4.157 in]
Stroke 100 mm [3.937 in]
Compression Ratio 8,7 : 1
Firing Order 1 - 3 - 2 - 4
Pilot's view Clockwise - seen from cockpit
Maximum Torque
(ISA conditions)
320 Nm [225 ft.lb] @ 2400 rpm
Power rating
(ISA conditions)
130 hp @ 3300 rpm /  123 hp @ 2800 rpm
Installed weight 81,6 kg (179,90 lbs) (including starter motor and alternator)
DC output 30 Amp (+/- 15 Amp available above engine/fuel pump needs)
Oil capacity 4 L (1,06 USgal)
Fuel (unleaded) MOGAS with min. 97 RON / 88 MON (= 93 AKI) octane rating or AVGAS

Power / Torque curve

The power and torque curve of the engine has been established by repeated dyno tests, which were performed at sea level and in weather conditions close to the ISA standard. The following graph shows the real, available power and torque coming from the crankshaft of the UL350iSA engine corrected to the International Standard Atmosphere conditions at sea level.

Power vs Density Altitude

The following graph shows the calculated available power of the UL350iSA engine at different RPM settings, WOT (wide open throttle) and varying density altitude.

Power vs MAP

Dimensions

Dimension Weight
Maximum dimension in X direction (length)* 553.0 mm [21.7 inch]
Maximum dimension in Y direction (width)* 736 mm [28.97 inch]
Maximum dimension in Z direction (height)* 472 mm [18.58 inch]

Weights

  • Dry weight of the basic standard engine from serial production: 66,1 kg (145,73 lb)
  • Ready-to–fly weight: 78,9 kg (173 lb)

For more details please check the technical data document.

Fuel consumption (Liter/hour)

Specific fuel consumption

These are values at full throttle. When cruising estimated average is UL350 ±18l.
(depending on type of plane, personal style of flying, cruise speed , climate circumstances)

The following is a list of the ULPower engine standard design features, all included at no additional cost.

  • Dual (redundant) electronic spark ignition (variable timing)
  • Multi-point electronic fuel injection with automatic altitude and temperature compensation
  • Electronic RPM limiter
  • Rubber mounts
  • Alu ram airboxes
  • Breather with Oil/Air separator (including: temperature resistant hoses and banjo connections)
  • Direct propeller drive
  • ECU (electronic control unit) and mil spec wiring loom
  • Wet sump forced lubrication with integrated pressure regulator
  • Stainless steel exhaust and muffler included
  • One electric fuel pump, two fuel filters, fuel pressure regulator (not included with the UL520T)
  • Oil and air filter
  • Oil and air temperature sensors, Oil and fuel pressure sensors, Air pressue sensor which provide data read-out through RS232 OR CANBUS

Extra options

  • EGT Sensor kit
  • CHT Sensor kit
  • Fuel connection kit
  • Oil Cooler kit
  • Double ecu
  • Different types of prop flanges
  • Different exhaust systems
  • Swiveling oil pick-up tube
  • Dual alternator
  • Forced air cooling
  • Intercooler kit

Please contact us for more info / prices

Collection of ULPower spare parts
More questions? We've got you covered!

Visit our engine FAQ or contact us.

Note: Pictures may not always represent the exact colour or shape.
All prices indicated are excluding taxes and transportation costs.
Deliveries to private individuals within the European Union are subject to 21% Belgian VAT. Prices subject to change without notice.